当前位置: 技术问答>linux和unix
装Linux分好分区总提示超过1024个柱面,怎么回事?
来源: 互联网 发布时间:2014-11-21
本文导语: 装Linux分好分区总提示超过1024个柱面,怎么回事? | linux的boot分区不能在8。4G以外。把LINUX装在8。4G以内就行了 | Sorry for reply in English. I am installing a Mandrake 8.2 server(Engl...
装Linux分好分区总提示超过1024个柱面,怎么回事?
|
linux的boot分区不能在8。4G以外。把LINUX装在8。4G以内就行了
|
Sorry for reply in English. I am installing a Mandrake 8.2
server(English) and using Mozilla to view this. No Chinese
input method for this server was intended.
The 1024 cylinder limited was imposed by the 16bit BIOS that
the boot sector must be within the 1st 1024 cylinder.
If you are using latest lilo, this limitation should have been
removed.
The easier way to handle the problem is to create a very small
partition say 10M within 1024 cylinder or 8.4G of your booting
hard disk. And format this partition for /boot and install
your linux as normal.
server(English) and using Mozilla to view this. No Chinese
input method for this server was intended.
The 1024 cylinder limited was imposed by the 16bit BIOS that
the boot sector must be within the 1st 1024 cylinder.
If you are using latest lilo, this limitation should have been
removed.
The easier way to handle the problem is to create a very small
partition say 10M within 1024 cylinder or 8.4G of your booting
hard disk. And format this partition for /boot and install
your linux as normal.
|
旧版本的是这样
找个新版的来用就可以了
我用的rh7.2把它放在了35--40G的地方
找个新版的来用就可以了
我用的rh7.2把它放在了35--40G的地方
|
看一下/etc/lilo.conf
需要有一行(可加在default=linux这行前面):
lba32
然后更新LILO:
/sbin/lilo
就可支持1024柱面以后的硬盘启动了。
需要有一行(可加在default=linux这行前面):
lba32
然后更新LILO:
/sbin/lilo
就可支持1024柱面以后的硬盘启动了。
|
你分一下boot区吧,分一个100兆左右,我就是这样解决的!